Percy 90 wall tee

press wall tee 90°

Iran Pipe’s 90-wall press-fit tee is one of the five-layer press-fit connections, which is used to connect two sub-branches from a main branch.

The minimum allowable breaking pressure for five-layer pipes in sizes 16, 20, 25 and 32 according to the standard is 60, 50, 40 and 40 bars, respectively.

Percy Connections

In this model, the steel ring on the connection is rotated on the press tube using a press jaw of the same size.

Due to the difference in the connection method in press and coupler connections, each of the connections has a special method for installation, and the initial stages are the same in both types of connections.

First, cut the pipe to the required size with scissors or a ruler, then use the caliber tool to widen the inside of the pipe a little, and use the blades at the end of the caliber to make the inner wall of the pipe in a circular motion. This work is very important because the wall of the pipe is thinned before calibrating, and the rubber O-ring may tear the connection during installation, and this can cause non-sealing and water leakage.

– The maximum permissible usage temperature for the five-layer pipes of Iran Pipe is 95 degrees centigrade, which these pipes can withstand this heat for long periods of time.< /span>

Press fittings are one of the most popular fittings for pex pipes or pex all pex pipes. This tube is usually placed on the spikes with two rubber O-rings. This is the only form of PEX fitting that is pressed. You can use a press for this.

Can PPR pipes be used to install a heating system?

Yes, it can and with high reliability. A pressure range of 20 is sufficient for central heating distribution of hot water heating (not steam heating). What is better for heat distribution are five-layer tubes reinforced with aluminum foil.